OLD GEN2 FIBERGLASS FILLER PANEL

The best place to buy and sell anything related to Spec Racer Fords
User avatar
Still Learning to Type
Still Learning to Type
Posts: 26
Joined: Sun Jul 06, 2014 11:14 pm
Location: Los Gatos, California
Chassis:
065
PostPosted: Wed Dec 05, 2018 3:03 am
We now have a mold and are producing a fiberglass part to help fill the old GEN2 vent above the exhaust. To install, remove the old vent, sand off the paint, cut down the new panel to match the opening, and bond the panel to the opening with fiber filled Bondo on top of the panel. After the filler dries, sand the inside, add a few layers of fiberglass, and then finish the exterior. The cost is $120 plus shipping, the can be ordered online at http://www.accelracetek.com, email us, or call us at (669) 232-4844.
Attachments
Panel #1.jpg
Panel #1.jpg (44.97 KiB) Viewed 149 times
Panel #2.jpg
Panel #2.jpg (38.74 KiB) Viewed 149 times

Return to Advertising

Who is online

Users browsing this forum: No registered users and 0 guests


cron