Hi I'm new to SRF and am converting a GEN 2 to GEN 3 . I assume the " scoop" in discussion is the forward facing air inlet on the left side between the wheel arch bulge and the hump over the engine???
Also on the conversion, I did not get a speedo drive gear on my upgraded gearbox, and didn't have one on the old 'box. From what I understand I need this for pitlane speed limiter. Is this required by GCR?
Rear Body Section for Gen3
23 posts
• Page 3 of 3 • 1, 2, 3
Still Learning to Type
Posts: 30
Joined: Sun Nov 19, 2017 1:35 pm |
|
Yes -- that's the scoop on the scoop over the wheel well, which needs to be removed on GEN3 for 2018.
Last edited by Bob Devol on Tue Jan 23, 2018 5:48 pm, edited 1 time in total.
|
|
If I'm reading this correctly, the gear drive is required per GCR (January 2018):
Final Drive Ratio: 3.62 or 3.85; 3.85 only 1/1/2018. For 3.62 Speedo drive gear must remain, for 3.85 Speedo drive gear must be installed. Previously sealed transmissions, as documented by seal numbers, are exempt until next rebuild or 1/1/2018. Bob Breton - SRF 51 - San Francisco Region
|
|
23 posts
• Page 3 of 3 • 1, 2, 3
Who is online
Users browsing this forum: No registered users and 9 guests