Question:
Is there a baseline torque/dyno chart for the gen3 out there somewhere? I don't mean a specific engine, I'm just looking for a torque/hp/rpm chart so that I can put together context-sensitive shift lights for my dash.
Gen3 Torque Chart?
5 posts
• Page 1 of 1
Needs a Life!!!
Posts: 228
Joined: Wed Dec 28, 2011 6:21 pm Location: Stillwater, Mn Chassis: 784 |
I think it is safe to say set the last light 100 rpms from the rev limit in all gears and go backwards from there.
Last edited by Bill Parenteau on Wed Mar 01, 2017 8:41 pm, edited 1 time in total.
|
Ready to Write a Book
Posts: 96
Joined: Sat May 03, 2014 12:14 pm Location: San Jose, Ca Chassis: 501 Facebook Page: http://www.facebook.com/kangamotorsports/ |
This is what is in the Gen3 conversion manual:
Optimum operation ranges HP peak: 6100 / 6300 rpm Torque peak: 4900 / 5100 rpm (- 6 Ft-lb from peak range 2800 / 6100 rpm) Lug limit:4000 / 4200 rpm Rev limiter:6750 rpm |
In my dyno tests, the HP peak appears to be well past the rev limiter (6,750). 100-150 rpm below the rev limiter will generally keep you off the rev limiter, which is desirable, since it takes about a 200 rpm drop to get off the rev limiter if it does kick in.
Bob Breton - SRF 51 - San Francisco Region
|
|
I set my first light at 6400 and my last two lights at 6650. Seems to be just enough to keep me off the rev limiter.
|
|
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests