The engine harness has a nice multi pin connector. One half appears to be made to mount in a bulkhead. How have people handled this connector where it passes through the aluminum panel in front of the left rear tire? Mount the connector in that panel? Just leave the multi pin connector in the side pod and run the harness around the upper right corner of the panel? Anyone have photos?
Thanks for your help.
Engine harness multi pin connector
2 posts
• Page 1 of 1
Ready to Write a Book
Posts: 84
Joined: Mon Sep 09, 2013 10:03 am Chassis: 469 |
Scott Ross
#469 |
Needs a Life!!!
Posts: 260
Joined: Wed Feb 08, 2012 8:45 pm Location: Daytona Beach, FL |
On all of our cars the two meet just passed main frame 2inch center rail. Just under where the center section would bolt to its hole on frame mount. That is only as far as the engine harness will go. So the ECU harness has to go to that point to reach engine harness. Real close to clutch slave line to Transmission. Southeast Spec Racer, Tony
|
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests