Hello
I am doing some winter work. Can anyone tell me what size the lower control arm rod ends are?
Rod Ends Sizes
8 posts
• Page 1 of 1
Forum Hermit
Posts: 158
Joined: Tue Dec 06, 2011 12:26 pm |
I only use Aurora rod ends for the LCA they are part number AU-PRM-10T.
But the answer to your question is .625 Bore, 5/8-18 Thread RH |
For sure, use a brand name rod end like Aurora, Ampep, etc. |
|
The lower control arm has two sizes. It has the big one out by the wheel and smaller ones at the frame. What size is the smaller one at the frame?
|
|
The inner is a RAM-7T or an AM-7T
|
|
Ready to Write a Book
Posts: 96
Joined: Sat May 03, 2014 12:14 pm Location: San Jose, Ca Chassis: 501 Facebook Page: http://www.facebook.com/kangamotorsports/ |
Perhaps it is the engineer in me but there is a difference in load rating between the RAM, AM and PRM series provided. The -7 or -10 specifies the size and T is for Teflon lined. But what is the reasoning for selecting one series (RA, A or PR) over the other? Cost? Shank or rod end failing before the upright? LCA failing before the rod end?
|
Needs a Life!!!
Posts: 1200
Joined: Wed Nov 30, 2011 1:38 am Location: Sunnyvale, CA Chassis: 068 415 Facebook Page: http://facebook.com/HSERacing |
http://www.specracer.com/forums/viewtopic.php?f=5&t=1827
https://www.pegasusautoracing.com/document.asp?DocID=TECH00110 Dave Harriman
"It looks crazy, I understand. But, we only live once and I am going to give it a good try." - Alex Zanardi |
Forum Hermit
Posts: 128
Joined: Thu Dec 01, 2011 8:35 pm Location: Hebron, CT Chassis: 008 Facebook Page: https://www.facebook.com/profile.php?id=1032406508 |
Check out F.K. Bearing too. High quality and reasonably priced. [That is the FK Bearings in CT, not China]
Les Kurz
NER SRF #31 Chassis #008 (GEN2) |
8 posts
• Page 1 of 1
Return to Technical and Repair Discussions
Who is online
Users browsing this forum: No registered users and 49 guests