bonding sheet metal
2 posts
• Page 1 of 1
I have my car down to frame while doing the Gen 3 conversion. I am surprised to find the floor pan was not bonded to the frame. I plan to bond it. We are allowed to correct? Bigger question is side aluminum panels. In some other tube frame classes you are not allowed to bond side sheet metal. Are we allowed to bond all aluminum?
|
|
Needs a Life!!!
Posts: 253
Joined: Wed Nov 30, 2011 1:09 pm Location: Off Agro Racing Chassis: 407 |
Yes. You can bond the sheet aluminum panels. Be sure to drill drain hole in the floor pan otherwise you will wind up with a lake inside your car.
|
2 posts
• Page 1 of 1
Return to Technical and Repair Discussions
Who is online
Users browsing this forum: No registered users and 11 guests