Freeing Up New Upper Ball Joint

Technical and Repair Discussions

Novice Typer
Novice Typer
Posts: 12
Joined: Wed Oct 07, 2015 8:44 am
PostPosted: Sun Nov 12, 2017 1:22 pm
I hope this is not repeat subject and apologize in advance if it is.

I'm looking to replace an upper ball joint (Moog K3082) and noticed that the brand new one is awfully stiff. Is there any known procedure to safely free them before install?

New Member
New Member
Posts: 9
Joined: Mon Oct 16, 2017 1:18 pm
PostPosted: Sun Nov 04, 2018 10:25 pm
As a newbie I had the same concern. CSR told me to put new one(s) on the rear, that is, if you have to replace a front, move a rear to the front and put the new one on the rear.

Ron

Return to Technical and Repair Discussions

Who is online

Users browsing this forum: No registered users and 1 guest