SpecRacer.com

The engine harness has a nice multi pin connector. One half appears to be made to mount in a bulkhead. How have people handled this connector where it passes through the aluminum panel in front of the left rear tire? Mount the connector in that panel? Just leave the multi pin connector in the side pod and run the harness around the upper right corner of the panel? Anyone have photos?

Thanks for your help.

On all of our cars the two meet just passed main frame 2inch center rail. Just under where the center section would bolt to its hole on frame mount. That is only as far as the engine harness will go. So the ECU harness has to go to that point to reach engine harness. Real close to clutch slave line to Transmission. Southeast Spec Racer, Tony