ECU Access using a Mac
Posted: Fri Nov 25, 2016 11:17 pmUnable to access the ECU using a Mac, any suggestions to try. Windows running with VMWARE. Thanks
Page 1 of 1
Posted: Fri Nov 25, 2016 11:17 pmRe: ECU Access using a Mac
Posted: Sat Nov 26, 2016 11:05 amI run Windows 10 using Bootcamp and I am able access it. I did have to use the firewire connection. A USB to Ethernet adapter would not work.
Re: ECU Access using a Mac
Posted: Sat Nov 26, 2016 11:29 amThanks, I will try looking at the firewall settings. I am using W-7 running under VMWare. I also have a windows netbook that I will try later today. Nikki and Mike mentioned there have been problems with Macs in the past. I also know of PC users having problems until they adjusted their Firewalls. All is good.. 
We were able to set the TPS manually,,, Thanks Nikki!!!
We were able to set the TPS manually,,, Thanks Nikki!!!Re: ECU Access using a Mac
Posted: Sun Nov 27, 2016 2:27 amI was never able to get the ECU connection to work through VMWare Fusion to Windows 7 or 10; booting directly into Bootcamp worked in Windows 7
I've had problems with Windows 10 through Bootcamp connecting to the ECU, but will retry again once I get an Ethernet adapter on my new MacBook Pro now that I've done a clean Windows 10 install. Interested in how the Firewire connection worked as I thought the only way to get access to the ECU was through an Ethernet connection.
I've had problems with Windows 10 through Bootcamp connecting to the ECU, but will retry again once I get an Ethernet adapter on my new MacBook Pro now that I've done a clean Windows 10 install. Interested in how the Firewire connection worked as I thought the only way to get access to the ECU was through an Ethernet connection.