Aim EVO4 and Mychron3 Dash
Posted: Mon Mar 28, 2016 2:55 pm
OK, first of all I appreciate all the help I can get on these tech items, as my expertise is about as limited as you can have.
I have decided to upgrade my AIM to take advantage of the information available from the ECU. I have purchased a new EVO4 and a Mcychron3 dash as the dash is similar to what I have used before.
I have downloaded the latest version of race studio 2 on my windows 7 computer, purchased and installed the proper ECU cable from AIM and wired the EVO4 correctly (separate switched). So far so good!
Now the hard part. My goal for now is to configure basic information including hooking up the GPS option. The basic information that I want on my Mychron3 Dash is of course RPM and Lap times.
In addition I would like the display to show the following:
A. engine water temp
B. engine oil pressure
C. A/F converted from Lambda
D. Fuel Pressure
Of course I would like to have voltage etc available but I am limited to 4 displayed items (I believe). I assume this information can be downloaded separately.
Now can someone give me the down and dirty easiest way to achieve my goals?
Are any of these items preconfigured on studio 2 for our specific ECU?
Do I need to configure the tire size for the speed sensor used on the trany?
Are there range configuration for such items as oil pressure, fuel pessure or water temp?
Does there have to be a math configuration for the Lambda conversion and if so how do I go about that?
Where is the best place to mount the GPS antenna and any suggestion relating to the need to configuration it?
Ok, I know I am asking for allot of information upfront, but I believe it's best to ask now, rather than
the total frustration that might be foreseen.
Thanks Pat
I have decided to upgrade my AIM to take advantage of the information available from the ECU. I have purchased a new EVO4 and a Mcychron3 dash as the dash is similar to what I have used before.
I have downloaded the latest version of race studio 2 on my windows 7 computer, purchased and installed the proper ECU cable from AIM and wired the EVO4 correctly (separate switched). So far so good!
Now the hard part. My goal for now is to configure basic information including hooking up the GPS option. The basic information that I want on my Mychron3 Dash is of course RPM and Lap times.
In addition I would like the display to show the following:
A. engine water temp
B. engine oil pressure
C. A/F converted from Lambda
D. Fuel Pressure
Of course I would like to have voltage etc available but I am limited to 4 displayed items (I believe). I assume this information can be downloaded separately.
Now can someone give me the down and dirty easiest way to achieve my goals?
Are any of these items preconfigured on studio 2 for our specific ECU?
Do I need to configure the tire size for the speed sensor used on the trany?
Are there range configuration for such items as oil pressure, fuel pessure or water temp?
Does there have to be a math configuration for the Lambda conversion and if so how do I go about that?
Where is the best place to mount the GPS antenna and any suggestion relating to the need to configuration it?
Ok, I know I am asking for allot of information upfront, but I believe it's best to ask now, rather than
the total frustration that might be foreseen.
Thanks Pat