Just another thing to put on the spare parts list, if it's not already there.Per Mike Davies, "The fuel & Oil sending units are not as reliable as I would like, I would only buy AC Delco Part # D1846A (Oil)".
Gen3 Oil Pressure Sender Failure
5 posts
• Page 1 of 1
Needs a Life!!!
Posts: 228
Joined: Wed Dec 28, 2011 6:21 pm Location: Stillwater, Mn Chassis: 784 |
Just an FYI. I had an oil pressure sending unit fail this last weekend. Fortunately I still have the old oil gauge installed, so I could tell I had good oil pressure.
|
Still Learning to Type
Posts: 37
Joined: Fri Aug 16, 2013 8:23 pm Location: Bixby, Oklahoma Chassis: 780 |
I had two oil pressure sending unit sensors fail on my car at NOLA in one weekend. I have raced four weekends since replacing the sensor with no other problems.
Richard Stephens |
My oil pressure is always pegged. Its been that way since I bought my car. I got a new oil pressure sender, but the issue continues. I assume I should have checked wiring first. Are there any manuals on wiring setup?
|
|
You may have a bad ground to that sensor if it is pegged.
|
|
Or, as Enzo and I went through recently with my GEN3 conversion, a bad ground at the dash panel gauges. |
|
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest